強人!自己做木制iPod

[img]http://www.52012.com/userfiles/gallery/2007112211344535471.jpg[/img]
改造原型：iPod 4代 20GB


[img]http://www.52012.com/userfiles/gallery/2007112211350635471.jpg[/img]
第一步：拆去后盖

[img]http://www.52012.com/userfiles/gallery/2007112211352135471.jpg[/img]

接着拆


[img]http://www.52012.com/userfiles/gallery/2007112211354835471.jpg[/img]
咱用的可不是木纹纸之类的东东，货真价实的实木－非洲紫檀(African Padauk)

[img]http://www.52012.com/userfiles/gallery/2007112211360635471.jpg[/img]
先把边角磨圆

[img]http://www.52012.com/userfiles/gallery/2007112211363835471.jpg[/img]
按照iPod的轮子大小挖空


[img]http://www.52012.com/userfiles/gallery/2007112211365535471.jpg[/img]
接下来准备凿出屏幕部分
[img]http://www.52012.com/userfiles/gallery/2007112211371335471.jpg[/img]

初步成型

[img]http://www.52012.com/userfiles/gallery/2007112211373135471.jpg[/img]
最困难的部分－背面，需要精工细酌

[img]http://www.52012.com/userfiles/gallery/2007112211375535471.jpg[/img]
做一块新的屏幕板，用的是lexan树脂板
[img]http://www.52012.com/userfiles/gallery/2007112211381535471.jpg[/img]
上清漆


[img]http://www.52012.com/userfiles/gallery/2007112211383435471.jpg[/img]
同样方法加工出来转轮，因为不是同一块木头，颜色有所偏差

[img]http://www.52012.com/userfiles/gallery/2007112211385735471.jpg[/img]
合体，用了双面胶来粘合触摸轮部分，还能正常工作
[img]http://www.52012.com/userfiles/gallery/2007112211392335471.jpg[/img]
重新介绍一下，木制iPod，手工打造，非洲紫檀，工作正常


[img]http://www.52012.com/userfiles/gallery/2007112211394035471.jpg[/img]
侧面观察一下


[img]http://www.52012.com/userfiles/gallery/2007112211401335471.jpg[/img]
细节


[img]http://www.52012.com/userfiles/gallery/2007112211402935471.jpg[/img]
和底座完美锲合

很 好看哦

强人.:) :) :)